Air In Pool Pump Lines

You can blow out your own pool lines with an air compressor or a wet rated powerful shop vacuum if you have the right components.

Air in pool pump lines.

The pool pump lid s o ring will wear out over time and lose its airtight seal allowing air to enter the pool pump from the top. When air exists in the intake line and the pump chamber the pump cannot draw water. Over time air becomes trapped inside the filter causing pressure to build up inside the filter body. Start with the suction side and move to the pressure side.

What happens when i. Over the 8 hours when the pump is not running air is getting into the lines above pool water level. And blow out pump components heaters and filter components this is a good time to clean skimmer filters. After the pump restarts and primes water flows normally and air bubbles eventually cease.

The last and most serious issue that could be occurring is air entering through cracked lines between the skinner and the pump. Pumpbasket filtersystem for more details and to purchase please visit. If you have checked everything above and still have air inside you pump filter or swimming pool return lines you will have to check the swimming pool suction line skimmers main drain and also pump suction valves for air. Using the above pool pump troubleshooting tips above you should be able to remove all the air from your swimming pool pump.

Removing air from a pool line involves priming the system with water to enable the pump to push the air out. There are no signs of water leaks anywhere. Another part of the pool s pump that can allow air to get into water return lines is the pool pump lid s seal rubber o ring or gasket. But it s important to be thorough.

This can only truly be checked by means of a pressurization test to see if the line holds air pressure and should be checked by a professional pool service company.